1312
General Information

READ AND FOLLOW ALL WARNING

AND CAUTION INFORMATION WHEN

INSTALLING THIS APPLIANCE.

• All openingsin the wall behind the
applianceand in the floor underthe
appliancemust be sealed.
• Do not obstructthe flow of combustionand
ventilationair.

Moving, Handling,and Unpacking

Removeand discard all packingmaterials,
includingcardboard and tapeon the outside
and insideof the range.
Removethe burner grates and styrofoam
off thetop cooking surface. Besure to
removethe burner caps packagedin
styrofoambelow the burner grates.
Do not discard the anti-tipmetal
bracket supplied with therange.
This is the anti-tip deviceand must
be installed with the unit.Refer to
“Anti-tip Device Installation”
section.
Some stainless steel parts may have a plastic
protective wrap which must be peeled off.
The interior should be washed thoroughly
with hot, soapy water to remove film
residues and any dust or debris before being
used, then rinsed and wiped dry. Solutions
stronger than soap and water are rarely
needed.

NOTICE

DO NOTuse the handle or ovendoor to
liftthe oven. Remove doorbefore
installation to ensurethat it is not used to
liftthe unit. DO NOT lift orcarry the door
by thehandle.
Removingthe door mustbe done by your
dealer,a qualifiedlicensed plumber, or
certifiedgas installer.

Door Removal

1
Open door completely.Place pins, supplied with unit, in
pin hole. Forpersonal safety, ONLY usepins
supplied withthe unit.
2
Remove hingetrim screws. Take off hinge trim. Identify
right and lefthinge for future re-installation.
3
Close untilpins stop door.
4
Lift door up andout.
Installation