MAINTENANCE
10)Remove all 8 screws holding the burner tray assembly in place.
11)Carefully lift the burner tray assembly out.
12)To replace the burner tray assembly, simply reverse these instructions.
To remove valve from valve assembly, continue.
13)Remove two (2) thermopile wires.
14)Remove thermocouple with a 9 mm (metric) wrench.
15)Remove pilot nut with an 11 mm wrench.
16)Remove valve to orifice nut with a 5/8" wrench.
17)Remove inlet pipe with pipe wrench. Note orientation of 90o elbow.
18)Remove two (2) phillips head M5 screws on each side of the valve.
19)Remove valve and remove gas out 90o brass fitting. Note orientation of fitting.
INSTALLING VALVE
ASSEMBLY
1)To install a new valve assembly, reverse instructions for removing valve. See assembly steps
2)Check for leaks and manifold pressure. See Gas Pressure Test instructions.
3)To reinstall valve, reverse instructions for removing valve assembly, steps
Waterford | 19 |