Waterford Appliances E63-NG1 This Conversion Must Be Done By A, Burner Orifice, Contains

INSTALLATION

9)Unscrew the pilot orifice with the allen key and replace with the LP pilot orifice in the kit.

Burner Orifice

10)Remove burner orifice with a 1/2" wrench and discard. Use a wrench to hold on to the elbow behind the orifice.

11)Reinstall new burner orifice LP stamped #50 and tighten.

12)Reverse steps 4) to 2).

13)Attach the Conversion label "This unit has been converted to Propane" on top of the Serial # decal. E63/E65: Part #175

E63/E65 Conversion Decal: 908-175

14)Replace yellow "Natural Gas" label with red "Propane" label

15)Check for gas leaks.

16)Check inlet and outlet pressures.

17)Check operation of flame control.

18)Check for proper flame appearance and glow on logs.

Reduction Kit to Lower Btu Rating for Emerald E65-1 Gas Stove

Natural Gas - Kit #: 260-920

Propane - Kit # 260-922

THIS CONVERSION MUST BE DONE BY A

QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !!

Natural Gas Conversion Kit 260-920

Contains:
Qty.Part #	Description

1904-593 Burner Orifice #40 (Natural Gas)

1	908-365	Decal "Converted to
		27,000 Btu"
1	908-363	Instruction Sheet
Propane Conversion Kit 260-922
Contains:
Qty.Part #		Description
1	904-390	Burner Orifice #52 (Propane)

1908-365 Decal "Converted to

29,000 Btu"

1 908-363 Instruction Sheet

1) Shut off the gas supply.

2)Open the valve door and remove the control panel.

3)Open the front door. Open the right side door and there is a cutout in the heat shield through which can be seen a wing nut threaded on to a stud attached to the front door. Loosen this nut by turning it counter- clockwise.

The wing nut that holds the front door is accessible through the cut-out in the right side heat shield.

4)Carefully remove the logs, embers and rock- wool.

5)Remove burner.

Note: Use a magnetic type screwdriver if possible.

Waterford E63-1 EMERALD Freestanding Gas Stove 11