Viking F20542B Door Replacement and Adjustment, Troubleshooting, Oven is not clean after self

Product Care

Door Replacement and Adjustment

1 2

Reinstall door to range.	Open door completely.
	Reinstall hinge trim.

3 4

Remove pins from hole in hinges. Close door.

5

If the door needs to be adjusted, loosen hinge trim screws located in step 2. Adjust the screws located between the door and kickplate using a 5/32” hex head allen wrench. After adjustment,

tighten hinge trim screws.

Troubleshooting

Problem	Possible Cause and/or Remedy
Range will not function.	Range is not connected to electrical power:
	Have electrician check power circuit breaker,
	wiring, and fuses.
Oven does not operate in	Door is not shut tight enough for automatic
self-clean.	door latch to lock.
Oven is not clean after self-	Temperature control knob not rotated all the
clean cycle.	way past clean until it stops.
Broil does not work.	Temperature control knob is rotated too far
	past broil position.
Door will not open.	Oven is still in self-clean mode. If oven is
	hot, door latch will release when safe
	temperature is reached.
Oven light will not work.	Light bulb is burned out.
	Range is not connected to power.
Igniters will not work.	Circuit is tripped.
	Fuse is blown.
	Range is not connected to power.
Igniters sparking but no	Gas supply valve is in “OFF” position.
flame ignition.
	Gas supply is interrupted.
Igniters sparking	Power supply is not grounded.
continuously after flame
ignition.	Power supply polarity is reversed.
	Igniters are wet or dirty.
Burner ignites but flame is	Burner ports are clogged.
large, distorted, or yellow.
	Unit is being operated on wrong type of gas.
	Air shutters not properly adjusted.
Strong odor and/or smoke	This is normal burn off of insulation and
is noticed first few times	protective oils in oven. This will go away	Product
oven will not heat	heating function once it has cooled.
oven is used.	after using oven a few times.
Oven indicator light on;	Oven is operating properly. Unit will resume
		Care

52 53