Viking RVDD330R Planning, Interior Blower Installation, Exterior Blower Installation, All Units

VIKING RANGE, LLC Downdraft Ventilators

PLANNING

Interior Blower Installation

Exterior Blower Installation

This downdraft blower system is	TYPICAL INSTALLATION
designed to be used to exhaust	COUNTER			CHIMNEY TOP
airborne contaminants when
cooking with a variety of gas	TOP		COOK TOP
or electric cooktops. It can be
mounted in island, peninsula,				AIR
or conventional wall locations.			GEAR	VENT
This unit can be easily installed			MOTOR
			COVER
following these basic steps:			BLOWER
• Cut out the countertop
			BOX
opening.				120 VAC
• Mount the unit in the cabi-				GROUNDED
				OUTLET
net.
• Install the Model VIDV500
Interior Blower				3-1/4" X 10"
• Connect the ductwork and
				DUCT CONNECTOR
electrical.
• Install the cooktop.			ELECTRICAL
			SPECIFICATIONS
Note: the high level of air flow
		120 VAC • 60 Hz • 4.0 A
of this appliance may effect the
gas flame on some types of gas
cooktops.This is NORMAL and

This downdraft blower system is designed to be used to ex- haust airborne contaminants when cooking with a variety of gas or electric cooktops. It can be mounted in island, peninsula, or conventional wall locations.

This unit can be easily installed following these basic steps:

•Cut out the countertop opening.

•Mount the unit in the cabinet.

•Install 10" round dis- charge plate

•Install Model VEDV900 or VEDV1200 (DIPR151RSS only) External Blower

•Connect the ductwork and electrical.

•Install the cooktop.

TYPICAL INSTALLATION

COUNTER TOP CHIMNEY TOP

COOK TOP

AIR

GEARMOTOR VENT

COVER

10" ROUND DISCHARGE PLATE

120 VAC GROUNDED OUTLET

10" ROUND DUCTWORK

ELECTRICAL

SPECIFICATIONS

120 VAC • 60 Hz • 6.0 A (max.)

will cause no harm, but can be

corrected by lowering the speed

of the blower.

Note: the high level of air flow of this appliance may effect the gas flame on some types of gas cooktops. This is NORMAL and will cause no harm, but can be corrected by lowering the speed of the blower.

TAKE MEASUREMENTS

All Units

1.Refer to the cooktop installation instructions for dimensions of cooktop, countertop cut-out, and cabinet requirements. The Model RVDD330R / CRVDD330R will fit in most 30" wide cabinets, the Model RVDD336R / CRVDD336R will fit in most 36" wide cabinets, and the Model RVDD345R / CRVDD345R will fit most 45" wide cabinets. However, it is recommended that oversized cabinets be used for easier installation.

2.Cooktop depth can vary greatly from one to another.This may cause the fit of these two appliances to be rather tight.

Pay special attention to the areas of potential interference high- lighted above. A countertop with (A) a raised lip and/or (B) a backsplash may not allow enough flat countertop for a proper installation. Note that 2" of flat countertop is required behind cooktop and that 1-3/4" is necessary between the back edge of the cooktop and the inside of cabinet back.

2