Viking RVDD345R Cut Countertop Opening, Ef C D B, Remove 2 screws and the gear motor cover

VIKING RANGE, LLCDowndraft Ventilators

PREPARE THE DOWNDRAFT

Exterior Blower Installation		10" ROUND
	MOTOR	DISCHARGE
	PLUG	PLATE
The downdraft is shipped without a blower. Purchase a Model	NUTS
VEDV900 Exterior Blower and mount the 10" discharge plate
to the downdraft as follows:	CLAMP
1. Place the downdraft on its back on a table of flat work surface.
	CHANNELS

2.Remove the 4 nuts and 2 clamp channels.

3.	Remove 2 screws and the gear motor cover.	SCREWS
			COVER
4.	Carefully position the10" discharge plate under the bottom
		GEARMOTOR	PLATE
	flange of the downdraft.
		COVER
5.	Connect motor plug.		ADDITIONAL
6.	Replace the gear motor cover and 2 sheet metal screws.
			SCREWS
7.	Replace the 2 clamp channels and start the 4 nuts, do not
	tighten.
8.	Slide blower left of right to desired position. Use cover plate
	(supplied) to close up any open space.
9.	Tighten 4 nuts to secure top of blower. Use additional screws		BOTTOM
	(supplied) through bottom flange to secure bottom of discharge

plate. FLANGE

CUT COUNTERTOP OPENING

All Units

1.Measure and cut the countertop opening for your width of cooktop and downdraft.

Cooktop Width & Model	30" RVGC3305B	36" RVGC3365B	45" RVEC3456B
	30" RVEC3305B	36" RVEC3365B	45" CRVEC3456B
	30" CRVGC3305B	36" CRVGC3365B
	30" CRVEC3305B	36" CRVEC3365B
For use with Downdraft Models	RVDD330R	RVDD336R	RVDD345R
	CRVDD330R	CRVDD336R	CRVDD345R
Cutout Dimensions A	29-1/8"	34-7/8"	42-7/8"
B	20-5/8"	20-5/8"	20-5/8"
C	27"	33"	42"
D	2-1/4"	2-1/4"	2-1/4"
E	1-1/16"	15/16"	7/16"
F	1-1/16"	15/16"	7/16"

EF

C

D

B

BLOWER MODEL	DIMENSIONS
VIDV500	18.25" x 18.214" x 7.569"
VEDV900	28.25" x 24.75" x 7.16"
VEDV1200	22" x 30.828" x 12.724"

A

6