MACHINE ASSEMBLY
CARING FOR YOUR MACHINE
Accelerator Tool
The accelerator tool prevents an air bubble from forming while blending and allows for the processing of very thick and/or
Using the Accelerator Tool:
•If thick mixtures stop circulating, you may
have trapped an air bubble. Insert the accelerator tool through the lid and stir to release it.
•Use it only with the lid locked in place and lid plug removed.
•The splash disk (near the top of the accelerator tool) and lid prevent the accelerator tool from hitting the blades.
•The container should not be more than 2⁄3 full when the accelerator tool is used.
•Do not use the accelerator tool for more than 30 consecutive seconds (to avoid overheating).
•Holding the accelerator tool straight should allow
WARNINGS!
Splash Disk
Splash Disk
Do not force the accelerator tool into the container. Excessive force may cause the accelerator tool to extend too far into the container and may cause damage to the blades.
Do not use the older accelerator tool that has a straight and smooth surface and no “step.” Use of the older model may cause damage to the blades.
When processing hot liquids or mixtures:
•The
•Do not start processing hot liquids on high speed. Always start processing hot liquids on low speed, then switch to high speed while the machine is running.
•Use caution with hot liquids. Liquids may spray from under the lid plug or escaping steam may cause scalding.
IMPORTANT NOTES!
Cleaning Products: Do not use abrasive cleaning agents or concentrated bleach when cleaning. Do not use any cleaners containing quanitary sanitizers on polycarbonate components (i.e., Advance containers, covers). Do not use any of the following cleaning products: automatic dishwashing detergents, oven cleaners, steel wool or other abrasive pads.
16 | 17 |
