4.3.3Assembly of the
1.Check that the
2.Cover
3.Cover
4.Fit the complete
5.Fit cap head screws (8460) and tighten them to fix the intermediate cover (8450) to the pump casing (0010).
0010
0701
8130
8440
8450
8460
Remark: The pump insert (8430) is centering the assembly in the pump casing (0010) with a tight fitting. Do not hit with a plastic hammer on the rotor shaft (0701) during assembly. If the assembly cannot be fitted by hand use long bolts to pull the intermediate cover (8450) against the pump casing (0010).
4.3.4Assembly of the separation can
1.Check that the
2.Cover
3.Fit the separation can (8330) over the inner magnetic rotor (8310). Take care of the correct position of the holes for the tightening bolts and the threaded holes for disassembly. The threaded holes should be in line with the cap head screws (8460).
4.Fit cylinder screws (8210) and tighten them crosswise to fix the separation can (8330) on the intermediate cover (8450).
8450
8460
8200
8330
8310
8210
8460
Remark: The cap head screws (8210) are fixing both the intermediate cover (8450) and separation can (8330) tightly on the pump casing (0010).
A.0500.551 – | 59 |