SPX Cooling Technologies TG MAG58-80, TG MAG185-125 Disassembly of separation can, Bearing set

4.2.6 Disassembly of separation can

1. Un-tighten cap head screws (8210) crosswise and remove them.

2. Use two cap head screws (8210) in the threaded holes of the flange

to remove the can (8330).

3. Take out O-ring (8200).

Take care not to damage the inner rotor magnet.

Removal of rotor and bearing assembly (back-pull-out) from the pump casing

1. Un-tighten cap head screws (8460) and remove them.

2. Use two bolts in the threaded holes of the intermediate cover (8450) to remove the complete back-pull-out assembly from the pump casing (0010).

3. Take out O-rings (8130) and (8440).

8200

8210

8330

8210

8130

8440

8450

8460

0010

4.2.7Disassembly of back-pull-out assembly

1.Place the back pull-out assembly on the workbench in vertical position.

2.Un-tighten cap head screws (8490) of the inner magnetic rotor (8310) crosswise and remove them.

3.Remove the inner magnetic rotor (8310) from the hub (8350-D)

Bearing set

8350

AB C D

8490

8310

52 A.0500.551 – IM-TGMAG/02.00 EN (02/2008)