GB | GB |
6 |
| 8 | Hotline |
6.1 | Problem | Solution |
No sound | Make sure that the On/Off switch (B7) on the headphones is | |
|
| in the "ON" position. |
|
| Are the |
|
| headphones (B10) constantly lit? |
|
| Check whether the AC adapter (C) is correctly connected and |
|
| check the condition of the battery packs. Details in sections |
|
| 4 and 5. |
|
| Check whether the audio source is switched on and emitting |
|
| a signal. |
|
| Have you connected the transmitter to the audio source? |
|
| If you are operating via an adjustable headphones socket on |
|
| your audio source, make sure that it is turned up high |
|
| enough (e.g. to about the middle setting). |
6.2 | Sound interference | Use the frequency selection control (A3) to change to a |
|
| different transmission frequency. |
|
| Reset the transmitter again (section 4.2.2). |
|
| Make sure that the interference is not being caused by your |
|
| audio source. |
|
| In certain cases it may be necessary to alter the position of |
|
| the transmitter horizontally and/or vertically. |
|
| Check the |
|
| Do not place the transmitter directly in front of a television |
|
| set, but at a distance of approx. 1 m. |
6.3 | Transmitter switches itself off | Increase the volume at the headphones socket or the phono |
|
| output of your audio source. If the audio signals are too |
|
| weak the transmitter will otherwise switch off automatically. |
|
| See 4.1.3. |
Contact Germany: | Telephone hotline 01805 / 404910 (0.12 € / min.) |
| or http://www.vivanco.de. |
European contacts can be found at http://www.vivanco.com.
9 | Technical data |
|
|
| Transmission frequency | 863 - 865 MHz |
|
| Transmission channels | 3 |
|
| Transmitting power, max | 10 mW |
|
| Frequency range |
| |
| > 45dB |
| |
| < 1,8% |
| |
| Power supply | Headphones: | 2 AAA batteries |
|
| Transmitter: | AC adapter, 12 Volt / 200 mA |
Automatic transmission
Technical data subject to alteration. 010403
10Licence
This Vivanco RF product conforms to the European R&TTE directive for RF systems in harmonised frequency ranges. These systems may be sold and operated in the EU and in EFTA countries.
Operation is not permitted in any countries not named.
The declaration of conformity is included at the end of this manual.
If these suggested solutions do not lead to the desired result, please contact your dealer.
7Warranty
The FMH 6050 is subject to a strict quality inspection in order to guarantee maximum functionality. However, a technical defect can never be entirely ruled out. Should a claim nevertheless arise, you will immediately receive a replacement for your defective device from your specialist dealer, provided that the following points are observed:
The warranty period is 24 months from the date of purchase.
The headphones system must be complete as described in the enclosed instruction manual.
Only if the above points are observed can the device be exchanged immediately by your specialist dealer. If the above points are not observed, Vivanco will naturally honour a warranty of 24 months from the date of purchase in accordance with legal warranty requirements.
The following are not covered by any form of guarantee:
devices tampered with by
damage caused by improper handling of the devices, failure to observe the instructions and damage caused by leaking batteries.
As a quality product the FMH 6050 naturally meets all national and European licence regulations in the licensed countries.
14 | 15 |
