Pause-Live-TV (PLT): This feature allows the viewer to pause the program (either from cable service without set-top box, or antenna) being watched and then to resume watching it at the point the TV was paused. The last three buttons at the bottom of the remote control operate this feature: II pauses the live program and starts recording for up to 29 minutes, I_ starts the playback, • and I_ on the Navigation Wheel allows rewind and forwarding in increments of 15 seconds at a time and • will exit the feature to live TV. You can also press TV or AV or COMP or HDMI to exit this feature directly to the different inputs. A high speed USB 2.0 device with a minimum of 1Gb of memory plugged into the USB, port multimedia must be used for better performance of this feature.
Note: This feature (Pause Live TV) requires certain conditions about the USB device:
a)At least 1 GB of memory.
b)Empty (no other files) formatted as FAT32 device.
c)Write speed higher than 10Mb/sec.
Consumer Electronics Control (CEC): This feature is only available through HDMI and allows control of other CEC compatible equipment (DVD players, Satellite receivers, etc.) through the HDMI connections. The TV receives information from the connected unit and the TV will
rename the input (HDMI1, HDMI2, HDMI3 or HDMI-Side) to the specific name or brand sent by the connected unit. If the second unit is to be permanently connected; Whenever this unit is turned on, the TV will recognize it and automatically turned on (if already off). If it is decided to turn off the TV, the TV will send a signal to the connected unit instructing it to shut down helping you to save energy by turning both units off.
