Getting Connected cont.
Connecting Speakers
The Speaker Terminals are located on the rear panel. There are two SPEAKER terminals. Be sure to connect the left channel (L), right channel (R), “+” (red) and
���������������������
Preparing the Speaker Cable
You can either use an exposed speaker wire or Banana Plug speaker cable.
Exposed Speaker Wire
1. Remove approximately 3/8” (10mm) of insulation
����
2. Twist the exposed wires together to prevent short circuits
•Before connecting the speakers, make sure that the CDG- 6000RV is disconnected from the power source.
•Do not let the bare speaker wires touch each other or another metal part of this unit. This could damage the
Determining the proper way to connect the speaker cables:
The speaker cable is a pair of insulated cables running side by side. One cable is colored or shaped differently , perhaps with a stripe, groove or ridges.
1.Connect one end of the striped (grooved, ridged, etc.) cable to the “+” (red) terminal on the rear panel of the
2.Connect the other end of the striped (grooved, ridged, etc.) cable to the “+” (red) terminal on the speaker.
3.Connect one end of the “plain” (NO stripes, grooves, ridges, etc.) cable to the
4.Connect the other end of the “plain” (NO stripes, grooves, ridges, etc.) cable to the
�������������
�����������
����������
4.Insert the bare wire
5.Tighten the knob until the wire is secure
���
����������������
11
