Hookup Diagrams
House of Worship/Full Band
For this example, there are four microphones connected to channels 1-4. These microphones can either be the optional UHF wireless channels, low-impedance corded microphones, or high-impedance corded microphones. Musical instruments are connected to channels 5-8. Note that when connecting instruments to channels 5-8, the LEVEL control will need to be set rather high due to the lower signal level from instrument output. It is preferable to use channels 1-4 for instruments if you are using less than four microphones. If there is a need to connect a laptop or other stereo music source, you can connect to the designated stereo inputs on channels 5/6-7/8.
For power output in this example, the PA-PRO 900 is confi gured for MAIN L/R+MONITOR output. A pair of passive speakers is powered via the MAIN L./R speaker connector. A passive monitor speaker is powered via the MONITOR speaker connector. An additional set of powered speakers can be connected to the MAIN OUT jacks on the front panel.
Recording can be done either with an optional SDR-3 SD recorder (optional accessory), or to an external recording device connected to the RCA record out jacks on the front panel.
NOTES:
UHF wireless mic channels require the SOURCE SELECT switch to be set to UHF.
POWER AMP ASSIGN switch must be best to MAIN L/
R+MONITOR
