VocoPro UHF-3200 owner manual Operations

Operations

If you will be using the UHF-3200 with stage monitors and/or P.A. system, try the following:

•Place the stage monitor directly behind the microphone.

•Locate the P.A. loudspeakers so that they point away from the rear of the microphone. (With the speakers located in these positions, the possibility of feedback is greatly reduced).

•Always check the stage setup before a performance to ensure optimum placement of microphone and monitors.

IMPORTANT: Every wireless microphone installation is a unique situation, and can present a variety of problems. Never attempt a live performance without first conducting a “walkthrough” test of the system in the performing area. If major changes (additional wireless systems or intercoms, relocation of scenery, etc.) have been made since the last walk-through test, check the wireless system again, as close to performance time as possible.

OPERATIONS

1.Press the POWER button on the UHF-3200 receiver’s front panel. The power LED on the receiver will be RED.

2.Adjust the receiver’s VOLUME controls to approximately 50%.

3.Switch the microphone’s POWER BUTTONS to the ON positions.

4.Talk or sing into the microphones. During normal operation, the Signal Indicator LED’s will light YELLOW when a microphone is being used.

5.Adjust the receiver’s VOLUME controls until the output levels are balanced with each other and other possible source output i.e. CD+G tracks.

12