ENGLISH | 13
Product SupportUnit fails to heat up. Lighted On/Off
Switch DOES NOT illuminate when
set to “I” (on) position.
Unit fails to heat up. Lighted On/Off
Switch DOES illuminate when set to
“I” (on) position.
NOTE: Always allow sufcient
time for unit to heat up and begin
producing steam.
Excessive gurgling in Hose and
Steam Nozzle / water drips from
Steam Nozzle.
Steam output is weak or intermittent.
Unit is not plugged in.
No water in unit.
Mineral build-up in unit.
Mineral build-up in unit.
Mineral build-up in unit.
Household circuit breaker / ground
fault interrupter has tripped or blown
a fuse.
Unit is damaged or otherwise in
need of repair.
Unit is damaged or otherwise in
need of repair.
Condensation build-up inside of
Steam Nozzle / Hose.
Water level in Water Reservoir is
running low.
Plug power cord into electrical outlet.
Refer to Care & Maintenance
section on Page 12 for details.
Refer to Care & Maintenance
section on Page 12 for details.
Refer to Care & Maintenance
section on Page 12 for details.
Reset circuit breaker / ground fault
interrupter, or replace fuse. For
assistance, contact a licensed electrician.
Immediately cease usage and unplug.
Contact Consumer Service for
assistance (see below for details).
Immediately cease usage and unplug.
Contact Consumer Service for
assistance (see below for details).
Some gurgling is a natural effect of
the steaming process. For excessive
gurgling or dripping water, point Steam
Nozzle downward and shake thoroughly
to remove excess water droplets.
Refer to Filling With Water procedure
on Page 9 to rell unit with water.
Refer to Filling With Water procedure
on Page 9 to ll unit with water.