10 | ENGLISH

GENERAL OPERATION

NOTE: Be sure that Water Tank has been lled and, if desired, the Fabric Brush is
connected before following these steps.
1. For rst-time use, remove protective plastic cover that is shipped on electrical plug. Plug
power cord into a convenient electrical outlet.
CAUTION: This unit uses a polarized electrical plug, with one prong that is larger than
the other. This plug will t into a wall outlet only one way. If the plug does not correctly
t in the outlet, contact a licensed electrician to install a proper outlet. Do not attempt to
alter plug or circumvent this safety feature in any way.
2. Set Lighted On/Off Switch to “I” (on) position, and verify that switch is illuminated.
3. After approximately 45 seconds of heating time, unit will begin producing a ow of steam from
Steam Nozzle.
NOTE: It is common for the unit to produce gurgling sounds and small amounts of water
during the rst few minutes of steaming. This is due to water condensation inside cold
Hose, and should be reduced as the Hose heats up.
4. Once steam ow is steady and excess condensation has been removed from Hose, you may
proceed with your steaming tasks. Refer to Fabric Steaming section on Page 11 for more
information about steaming garments and other fabrics.
CAUTION: Always be sure that Steam Nozzle is pointed in a safe direction (away from
yourself, other people, pets and plants) when steaming.
5. When you are nished using the Everyday Fabric Steamer, immediately set Lighted On/Off
switch to “O” (off) position and unplug power cord from electrical outlet. Refer to Storage &
Care on Page 12 for proper cleaning and storage procedures.
Using Your
Everyday Fabric Steamer