8 | ENGLISH

CONNECTING HOSE

1. Place end of Hose onto threaded Hose Base (FIGURE 6-A).
2. Rotate coupling in clockwise direction until Hose is tightly secured onto Hose Base
(FIGURE 6-B). Hand tighten only. Do not over-tighten.
3. Hang Steam Nozzle on specially designed Steam Nozzle Cradle (FIGURE 6-C).
CAUTION: To prevent steam from causing bodily injury or damage to surfaces, always hang
Steam Nozzle on Steam Nozzle Cradle when not in use. Do not lay Hose on the oor as
condensation may build up, causing unwanted water droplets in the steam. Do not pull on
the Hose with excessive force as this may damage it, resulting in a steam leak.

CONNECTING FABRIC BRUSH

1. Make sure Lighted On/Off Switch is set to “O” (off) position, and that unit is not emitting any steam.
CAUTION: Do not try to connect Fabric Brush while unit is emitting steam, as this can
cause burns and injury.
2. Align Fabric Brush with Steam Nozzle as shown (FIGURE 7).
3. Press Fabric Brush rmly onto Steam Nozzle. The two pegs will t into the two larger holes on
face of the nozzle, while latch ts over top of the nozzle (FIGURE 7-A).
Your new SF-510 Everyday Fabric Steamer
is now fully assembled and ready for use.
Please continue reading this manual for
instructions on using the Everyday Fabric
Steamer, as well as directions for proper
cleaning, storage and troubleshooting.
Assembling Your
Everyday Fabric Steamer
FIGURE 7
6-A
7-A
6-B
6-C
FIGURE 6