10
3. Press the VC-12’s BANK UP switch.
The VC-12’s BANK display shows .
Switch LEDs (1-4) that contain no program
data are off, while those that do contain
program data are on.
4. Use switches 1 through 4 to select the
memory (1, 2, 3, or 4) into which you
want to store the program data. The
selection method you need to use
depends on whether the switch’s LED is
on or off, as follows.
If the switch LED is off, pressing the switch
once will select its memory and its LED will
flash.
If the switch LED is on, you’ll need to press
the switch for at least three seconds in
order to select its memory, and its LED will
flash quickly.
If you want to cancel your selection and
choose another memory, press the switch
again, or press the VC-12’s RECALL
switch. The switch’s LED will stop flashing.
Note: Previously stored program data will be
overwritten by the next step and there is no
undo!
5. To store the program data to the se-
lected memory, press your Valvetronix
amp’s [WRITE] button.
The data is transferred from your
Valvetronix amp and stored in the VC-12.
The corresponding switch LED (1–4)
comes on, indicating that the memory now
contains program data.
6. Turn off your Valvetronix amp, and then
turn it back on again.
That completes the procedure for storing
data.
Loading Program Data
Program data stored in your VC-12 can be
loaded into your Valvetronix amp as follows.
1. Turn off your Valvetronix amp and make
sure it’s connected to the VC-12’s VOX
BUS MAIN connector.
Note: Don’t connect anything to the VC-12’s
VOX BUS SUB connector.
2. On your Valvetronix amp, while holding
down the DELAY [TAP] button and the
REVERB [TYPE] button, turn on your
amp.
The VC-12’s BANK display shows .
3. Press the VC-12’s BANK DOWN switch.
The VC-12’s BANK display shows .
4. Use switches 1 through 4 to select the
memory (1, 2, 3, or 4) containing the
program data that you want to load.
The switch’s LED flashes.
If you want to cancel the procedure at this
point, press the switch again, or press the
VC-12’s RECALL switch.
5. To load the selected memory’s program
data, press the VC-12’s CHANNEL–FX
ON/OFF switch.
The program data is sent to your
Valvetronix amp.
When the data loading process is com-
plete, “4.” appears on your Valvetronix
amp’s BANK display.
6. Turn off your Valvetronix amp, and then
turn it on again.
That completes the procedure for loading
data.