Getting started
Battery charging
Once you have installed the battery, the screen indicates the battery status (see the table below).
• For best performance, keep the handset in the telephone base or charger when not in use.
•The battery is fully charged after 11 hours of continuous charging.
•If you place the handset in the telephone base or the charger without plugging in the battery, the screen displays NO BATTERY..
|
|
| Battery indicators | Battery status | Action |
|
|
|
|
|
|
| The screen is blank, or | The battery has no or very | Charge without interruption | ||
| displays Put in charger and | little charge. The handset | (at least 30 minutes). | ||
|
|
| flashes. | cannot be used. |
|
|
|
| |||
|
|
|
|
|
|
| The screen displays | The battery has enough | Charge without interruption | ||
| Low battery and | charge to be used for a short | (about 30 minutes). | ||
|
|
| flashes. | time. |
|
|
|
|
| ||
|
|
|
|
|
|
| The screen displays | The battery is charged. | To keep the battery charged, | ||
| HANDSET X. |
| place it in the telephone | ||
|
|
|
|
| base or charger when not |
|
|
|
|
| in use. |
|
|
|
|
|
|
When the battery is fully charged, you can expect the following performance:
Operation | Operating time |
|
|
While in handset use (talking*) | Up to 7 hours |
|
|
While in speakerphone mode (talking*) | Up to 3.5 hours |
|
|
While not in use (standby**) | Up to 5 days |
|
|
*Operating times vary depending on your actual use and the age of the battery. **Handset is not charging or in use.
After you install your telephone or power returns following a power outage, |
|
|
|
Date: MM/DD/YY | |||
the handset will prompt you to set the date and time. For instructions, see |
|
|
|
Set date and time on page 12. To skip setting, press CANCEL. |
|
| ECO |
|
|
|
|
|
|
|
|
