Installation
Charge the Handset Battery
Place the handset in the base. CHARGING... will display. Be sure to charge the battery for at least 16 hours before using your phone.
Set Language
•Press PROG, then press 
or 
until LANGUAGE is displayed. Press SELECT.
•The current setting blinks. Press 
or 
until the screen displays the correct language (English or Spanish).
•Press SELECT to save your selection.
Check for Dial Tone
After the batteries are charged, pick up the handset and press TALK; you should hear a dial tone. If you do not, try this phone in another phone jack
Set the Dial Mode
If you have touch tone service, the phone is ready to use as soon as the battery is charged. If you have pulse (rotary) service, you’ll need to change the dial mode.
•Press PROG.
•Press 
or 
until the screen displays DIAL MODE: and the current setting.
•Press SELECT. The current setting blinks.
•Press 
or 
to select TONE or PULSE.
•Press SELECT to save.
•If the phone will not be used for a long period of time, remove the battery to prevent possible leakage.
•If you have any trouble installing your phone, please refer to the
Troubleshooting section near the end of this manual.
Getting Started
www.vtechphones.com | GETTING STARTED |
