Vulcan-Hart C24GA6, ML-136022, ML-136021, C24GA10 Troubleshooting, Service And Parts Information

C24GA SERIES GAS CONVECTION STEAMERS

TROUBLESHOOTING

SYMPTOMS	POSSIBLE CAUSES	REMEDY
Unit not steaming	Gas supply is off	Turn on gas supply.
	Power cord is unplugged	Plug in power cord.
	Power switch is off	Press power switch on.
	Water supply is off	Turn on water supply.
	Burner control goes into 100%	Shut off the power, wait 5
	lockout	minutes, then turn power back on
		to restart ignition.
		If symptom persists, contact your
		Authorized Vulcan-Hart Servicer.
Door leaks	Damaged door gasket	Check door gasket for damage. If
		adjustment is needed, contact
		your Authorized Vulcan-Hart
		Servicer.
	Plugged drain or screen	Clear compartment cavity screen.
		If symptom persists, contact your
		Authorized Vulcan-Hart Servicer.
Water accumulates in	Drain clogged	Unclog drain.
compartment	Not leveled properly	Level per instructions in this
		manual.
Water not being	Water supply valve is off	Turn valve on.
supplied to generator	Water pressure low	Check water supply pressure.
	Water filter is plugged	Refer to water filter manual. If
		symptom persists, contact your
		Authorized Vulcan-Hart Servicer.
Steam is exiting from	Generator pressure is too high	Contact your Authorized Vulcan-
under unit		Hart Servicer.

SERVICE AND PARTS INFORMATION

To obtain service and parts information concerning this model, contact the Vulcan-Hart Service Agency in your area (refer to our website, www.vulcanhart.com for a complete listing of Authorized Service and Parts depots).

When calling for service, the following information must be available: model number, serial number, manufacture date (MD) and voltage.

F-35423 Rev A. (08-06) — 20 — PRINTED IN U.S.A.