GENERAL
INTRODUCTION
Models
This service manual was written for:
EF3, EF4 and EF5 Gas Fryers.
INSTALLATION
Generally, installations are made by the dealer or contracted by the dealer or owner. Detailed installation instructions are included in the Installation and Operation Manual, which is sent with each fryer.
OIL FILTERING
Filtering instructions are included in the Installation and Operation Manual.
NOTE: If pilot does not remain lit, repeat steps 2 through 5, but allow a longer period of time before releasing the combination valve knob. Adjust pilot flame, if necessary, as outlined under Pilot Adjustment in Service Procedures and Adjustments.
6. Turn combination valve knob to ON.
SPECIFICATIONS
Gas Data
Model | No. Tubes | BTU/HR |
|
|
|
EF3 | 3 | 90,000 |
|
|
|
EF4 | 4 | 120,000 |
|
|
|
EF5 | 5 | 150,000 |
|
|
|
OPERATION
Detailed operation instructions are included with each fryer in the Installation and Operation Manual.
CLEANING
Detailed cleaning procedures are included in the Installation and Operation Manual.
LIGHTING PILOT
1.Turn thermostat OFF.
2.Push combination valve knob in and turn to OFF.
3.Wait 5 minutes for unburned gas to vent.
4.Push combination valve knob in and turn to
PILOT.
5.While holding the combination valve knob in, light the pilot with a lit taper. Hold the combination valve knob in for approximately 30 seconds before releasing.
TOOLS
Standard
•Hand tools (standard set)
•VOM with AC current tester (any quality VOM with a sensitivity of at least 20,000 ohms per volt can be used)
•Gas test kit
•Temperature tester (thermocouple type)
•Manometer
– 3 –
