ELECTRIC FRYERS - REMOVAL AND REPLACEMENT OF PARTS
TILT SWITCH
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AT THE MAIN CIRCUIT BOX. THERE MAY BE TWO SEPARATE CIRCUITS. BE SURE BOTH ARE DISCONNECTED. PLACE A TAG ON THE CIRCUIT BOX INDICATING THE CIRCUIT IS BEING SERVICED.
1.Remove head cover screws.
2.Lift head cover enough to access tilt switch mounting screws and remove screws.
NOTE: Do not bend or kink high limit capillary tube.
3.Disconnect tilt switch lead wires.
FILTER-READY RETURN
VALVE SWITCH
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AT THE MAIN CIRCUIT BOX. THERE MAY BE TWO SEPARATE CIRCUITS. BE SURE BOTH ARE DISCONNECTED. PLACE A TAG ON THE CIRCUIT BOX INDICATING THE CIRCUIT IS BEING SERVICED.
1.Open front door.
2.Disconnect lead wires to return valve switch.
3.Remove switch mounting screws.
4.Remove tilt switch.
5.Reverse procedure to install and adjust as outlined under “ TILT SWITCH ADJUSTMENT”.
4.Reverse procedure to install.
Note: Switch mounting is a fixed location and has no provision for adjustment. The normally open contacts close before the valve handle is in the full open position.
9
