Vulcan-Hart GRD35F ML-126732 General, Assembly, Operation And Care Of, Save These Instructions

OPERATION AND CARE OF

KLEENSCREEN FILTRATION SYSTEM

SAVE THESE INSTRUCTIONS

GENERAL

The KleenScreen Filtration System filters the oil as it is pumped back to its respective tank. Valves inside the doors under each fry tank must be set so only one tank is being drained, filtered and pumped back at any one time.

The KleenScreen Filtration System is used on the following Vulcan Fryer Models:

	Gas Fryers		Electric Fryers
GR35F	GRD35F	GRC35F	ERD50F	ERC50F
GR45F	GRD45F	GRC45F	ERD85F	ERC85F
GR65F	GRD65F	GRC65F
GR85F	GRD85F	GRC85F

ASSEMBLY

1.After unpacking, wash the filter tank, crumb basket and filter screen. Use dishwashing detergent and warm water, or clean the components in a dishwasher. Rinse the filter tank, crumb basket and filter screen thoroughly. Wipe components dry with a clean cloth.

2.Pull the filter drawer out.

3.Place the filter tank in the filter drawer. Hang the crumb basket from the left tank handle inside the filter tank (Figs. 1 and 2). Position the filter screen assembly flat on the bottom of the filter tank so the filter orifice underneath the screen fits the suction hole in the bottom of the tank (Figs. 1 and 2). Close the drawer.

4.Make sure the two O-Rings are in place inside the filter suction port (Figs. 1 and 2). As the drawer is closed, make sure the filter suction connector fits tightly into the filter suction port (Figs. 1 and 2).

– 3 –