Disconnect the electrical power and follow lockout/tagout procedures
THERMOSTAT REMOVAL
1.Remove the control panel
2.Remove the knob
3.Label and disconnect the wires
4.Remove the thermostat retaining nut on the knob shaft.
5.Reverse procedure to install while being careful to install the thermostat in the same orientation.
TEMPERATURE PROBE
The temperature probe is an embedded K type thermocouple assembly.
Disconnect | the | |
| ||
| electrical power and | follow |
| lockout/tagout procedures |
|
TEMPERATURE PROBE REMOVAL
1. Remove the control panel
2. Remove the back panel
3. Label and disconnect the lead wires at the temperature controller
4. Unthread the probe retaining nut and remove the probe from the back of the unit.
TEMPERATURE PROBE INSTALLATION
1. Insert lead wires from back of heatshield through to temperature controller.
2. Apply a thin coating of high temp(500° F min. rated),copper based heat transfer and
3. Insert probe end into plate socket and hand tighten probe retaining nut.
4. Tighten the probe an additional ½ turn only with a wrench. Over tightening can strip threads and damage probe tip.
- 8 -