V SERIES FOOD HOLDING, TRANSPORT, & BANQUET CARTS |
GENERAL
INTRODUCTION
It is suggested that you thoroughly read this entire manual and carefully follow all of the instructions provided.
The V Series Holding & Transport Cabinets and Banquet Carts provide an efficient means of transporting and holding bulk prepared foods at proper serving temperatures.
INSTALLATION
Before installing, verify that the electrical service agrees with the specifications on the rating plate located on the lower back corner of the cabinet. If the supply and equipment requirements do not agree, do not proceed with unpacking and installation. Contact your Vulcan- Hart Customer Service Department immediately.
UNPACKING:
The Cabinet was inspected before leaving the factory. The transportation company assumes full responsibility for safe delivery upon acceptance of the shipment. Immediately after unpacking, check for possible shipping damage to the cabinet.
If the cabinet is found to be damaged, save the packaging material and contact the carrier within 15 days of delivery.
Carefully unpack and place in a work accessible area as near the installation position as possible.
1.Open the door and carefully remove any packaging materials and the retaining straps that hold the wire plate racks (Banquet Carts) or the tray slides and tray slide upright side supports (Holding & Transport Cabinets).
2.Peel off vinyl protection film.
3.On Banquet Carts, lift the plate racks into position on the side brackets.
4.On Holding & Transport Cabinets, remove cardboard element cover protector from cabinet bottom.
Remove adjustable tray slides from box.
Remove the tray slide supports and install them in the cabinet.
a.Hook the openings in the flat flange of the support over two vertical carriage bolts on the interior of the cabinet.
b.Make sure all flanges on the four supports face the door opening.
Install tray slides in the cabinet. Make sure the hook on the end of the tray slide is up.
3
