The Wadia 270 has several functions that can be configured to match your system
You can change the configurations by using the remote control.
Q The factory configurations settings will work in all systems. You can begin listening to your Wadia 270 without adjusting the configuration settings, then adjust them for maximum performance at a convenient time.
You can configure each digital output separately. There are two modes available for each output:
OFF: Turns off the signal from this output, as well as the circuitry used to drive the output. Turning off unused outputs will result in a small but noticeable improvement in sound quality.
ON: Turns on the signal.
The factory setting is All outputs ON.
There are two ClockLink modes:
E N A B L E D M O D E :
In this mode, the Wadia 270 will sense whether there is a ClockLink signal connected.
If there is, the Wadia 270 will automatically engage Clocklink. If there is no Clocklink cable connected, the Wadia 270 will disengage Clocklink.
In Enabled Mode, the display will indicate Clocklink status during CD playback.
DISABLED MODE:
In this mode, the Wadia 270 will disengage Clocklink even if it is connected to a ClockLink cable. If your Wadia Decoding Computer does not have a Clocklink output, switching to the Disabled Mode will result in a slight improvement in sound quality.
In Disabled Mode, the display will not indicate ClockLink status during CD playback.
The factory setting is ENABLED mode.
