Wadia Digital 270 operation manual Mode A, Mode B

When the Wadia 270 is turned on, it will automatically switch to a preset Resolution Enhancement Mode. You can configure the Wadia 270 to switch to your preferred Resolution Enhancement Mode. For more information, see Resolution Mode Select under Operation.

There are three Resolution Enhancement modes:
MODE A:	In this mode, the dither is processed using a	high-passdither filter.
MODE B:	In this mode, the dither is processed using a	low-passdither filter.
OFF:	Resolution Enhancement disabled.

The factory setting is Mode A.

The same sequence is used to change any of the configuration settings:

1.Press the ENTER key ( +-I) on the remote control repeatedly until the desired configuration screen appears.

2. Use the VOLUME UP ( A+) and VOLUME DOWN (I-)keys to select the desired configuration setting.

3. Use the MUTE key to save your selection.

To avoid accidentally re-configuring a different Wadia component, hold the remote very close to the display of the unit you would like to configure.

When you change the configuration the new setting will be saved even if you turn the power off.

For example, to configure Digital Out 1 to the OFF setting, use the following steps:

1.Press the ENTER key until the “Configure Out 1 II screen appears as shown below:

2. The factory setting is ON, so press the VOLUME UP or VOLUME DOWN keys to select between ON and OFF. When OFF has been selected, the display looks like this:

3 . The setting is not changed (or saved) until the MUTE key is pressed. NOTE: If you do n o t press any key for ten seconds, the display will revert to the status screen.