CLEAN UP
SHORT-TERM/OVERNIGHT STORAGE
Shut-down
1.Lock the gun and reduce the pressure. Turn the sprayer to prime A and shut it off. Unplug sprayer. Leave the suction set in the paint. Refer to Pressure Relief Procedure.
2.For latex materials only, pour 1/2 cup water slowly on the top of the paint to prevent the paint from drying. For other materials, seal the paint container with a piece of plastic while the suction tube is still in the paint. See Figure 33.
– OR –
Figure 33 – Add 1/2 Cup Water to Latex Paint
Seal Container for Other Materials.
3.Wrap the spray gun (completely assembled) in a damp cloth and place it in a plastic bag. Seal the bag shut. See Figure 34.
Figure 34 - Place Gun in Sealed Bag
4.Place the sprayer in a safe place out of the sun for
Start-up
1.Remove the gun from the plastic bag.
2.Stir the water into the paint for latex materials. Re- move the seal from the paint bucket and stir the paint for all other materials.
Figure 35 - Stir Material Before Spraying
3.Check to be sure the sprayer is in the Prime A position with the pressure completely reduced.
4.Plug sprayer in and turn on.
5.Turn the sprayer to Spray B and gradually increase the pressure.
6.Test the sprayer on a practice piece and begin spraying.
Figure 36 - Test on scrap material.
19
