Cleanup and Storage
Flush Material From Sprayer
MINERAL or
SPIRITS
Start | 1 What you’ll need |
•Warm, soapy water if using latex material
•Mineral spirits if using oil- based material
•Waste container
2 Cleaning Notes
•When using latex material, clean sprayer and components with warm, soapy water. For oil based material use mineral spirits. Never use mineral spirits with latex materials
•NEVER use gasoline to clean sprayer
•Dispose of used cleaning solution properly
•Thorough cleaning and lubrication of sprayer is important to ensure proper operation after storage
•If you flush your sprayer with mineral spirits, repeat
Flush Material From Sprayer instructions using warm- soapy water
3 Perform Pressure Relief Procedure
Page 7
4 |
4.Remove spray tip and guard and place in cleaning solution
5HANDLE
HANDLE
5.Empty material from hopper into original material container. Make sure to lift with your legs and not your back to avoid injury.
Follow these steps whenever cleaning with mineral spirits:
•If spraying or cleaning with
•Ground the gun by holding it against the edge of a metal container while purging.
Failure to do so may lead to a static electric discharge which may cause a fire
•Always flush spray gun at least one hose length from spray pump
•If collecting flushed solvent in one gallon metal container, place it into an empty five gallon container, then flush
•Area must be free from vapors
•Follow all cleanup instructions
6
7
6.Fill hopper with appropriate cleaning solution
7.Point spray gun at side of waste container
8 |
|
|
|
| SQUEEZE |
|
|
9 | ON |
| l |
|
| ||
|
|
| |
10 |
| N |
|
R |
| ||
U |
|
| |
T |
|
| |
8.Squeeze trigger
9.Turn power ON
10.Turn knob to SPRAY
11 |
11.Continue squeezing trigger until fluid is coming out clear.
Repeat as necessary
12
| N |
U | R |
T |
|
OFF | O |
|
12.Turn knob to PRIME and squeeze trigger until pressure is relieved. Release trigger, lock
spray gun, turn power OFF
18 | Cleanup and Storage • Clean the Sprayer |
|
English | ||
|
|
|
