Wagner SprayTech 9140S, 9210 Preparing the Sprayer for LONG- Term Storage, Shutdown, Startup

STORAGE

SHORT-TERM STORAGE (UP TO 16 HOURS)

Follow these steps when using latex paints only. If using materials that are oil-based, follow the long-term storage steps.

SHUTDOWN

1. Lock the spray gun off.

GX-06/07

GX-08/10

2. Turn the PRIME/SPRAY knob to PRIME.

PRIME SPRAY

3. Switch the pump OFF, and unplug the sprayer.

o

4.Pour 1/2 cup water slowly on the top of the paint to prevent the paint from drying.

5.Wrap the spray gun assembly in a damp cloth and place it in a plastic bag. Seal the bag shut.

6.Place the sprayer in a safe place out of the sun for short- term storage.

STARTUP

1. Remove the gun from the plastic bag.

2. Stir the water into the paint.

3. Check to be sure that the PRIME/SPRAY knob is set to

PRIME.

4. Plug sprayer in and

PREPARING THE SPRAYER FOR LONG- TERM STORAGE

1.Fill a cup or other container with separating oil (approximately 2 ounces) supplied with the unit and submerge the inlet valve into the oil.

2.Place a rag over the spray hose port, and turn the switch ON (l).

3.When the oil has been sucked from the cup, switch the pump OFF.

4.Insert the pusher stem into the inlet valve. Make sure the pusher stem is inserted fully.

Inlet valve

The pusher stem is designed to do two things:

•It holds the oil in the valve to keep the carbide seat from rusting.

•Secondly, it will keep the ball off of the seat to prevent any paint residue deposits that will cause the ball to stick to the seat. Paint deposits or rust formed on the carbide seat will cause priming and operation problems during repeated uses.

5.Wipe the entire unit, hose and gun with a damp cloth to remove accumulated paint.

6.Replace the high pressure hose to the paint hose port.

turn the switch to

PRIME

ON.
5. Turn the	l
PRIME/SPRAY
	SPRAY
knob to SPRAY.

6. Test the sprayer on

a practice piece and begin spraying.

English Customer Service: 800-880-0993 12 © 2003 Wagner Spray Tech - All rights reserved.