Wagner SprayTech 9210 Setup--Assembling The Sprayer, GX-06/07, GX-08/10, GX-07, GX-10, English

Models: 9210

1 20
Download 20 pages 22.74 Kb
Page 5
Image 5
SETUP--ASSEMBLING THE SPRAYER

SETUP--ASSEMBLING THE SPRAYER

TOOLS NEEDED FOR SETUP

Two adjustable wrenches

3/16” allen wrench

Extension cord (refer to Important Electrical Information (page 3).

TOOLS NEEDED FOR SETUPWARNING

Do not plug in the unit until setup is complete.

ATTACHING THE HANDLE (CART MODELS)

1.Position the handle against the cart so that the holes in the handle

line up with the holes in the cart.

2. Insert the bolts through the holes in the handle and cart and locking washers.

3. Tighten the wing nuts onto the bolts by hand.

ATTACHING THE PAIL BRACKET (CART MODELS)

1. Position the pail bracket against the unit so that the holes in the unit line up with the holes in the

ATTACHING THE SPRAY GUN

1. Thread spray gun onto the other end of the hose.

Hold the gun with one adjustable wrench, and tighten with the other.
ATTACHING THE SUCTION SET & RETURN TUBE

1.Attach the suction tube to the inlet valve and tighten firmly by hand. Be sure that the threads are straight so that the fitting turns freely.

2.Press the return tube onto the return tube fitting.

3.Squeeze clip over the return tube fitting to secure return tube.

Return tube

•Extension cord (refer to Important Electrical Information (page 3).fitting

Do not plug in the unit until setup is complete.ATTACHING THE HANDLE (CART MODELS) Inlet valve

ATTACHING THE PAIL BRACKET (CART MODELS)Clip

Return tube

ATTACHING THE SPRAY GUNHold the gun with one adjustable wrench, and tighten with the other.ATTACHING THE SUCTION SET & RETURN TUBESuction set

LOCKING AND UNLOCKING THE SPRAY GUN

LOCKING AND UNLOCKING THE SPRAY GUNWARNING

Always lock the trigger off when attaching the spray tip or when the spray gun is not in use. Refer to Spray Gun/Tip Chart on page 4 to determine the gun model you have.

bracket.

2. Insert the bolts through the holes in the bracket and the unit.

3. Tighten the bolts with a 3/16” allen wrench.

ATTACHING THE PAINT HOSE

GUN MODELS GX-06AND

GX-07

The gun is secured when the trigger lock is at a 90° angle (perpendicular) to the trigger in either direction.

GX-06/07

Gun locked (gun will not spray)

1.Thread the high pressure hose to the paint hose port.

2.Tighten with an adjustable

wrench.

3. Remove pusher stem from inlet valve.

GX-08/10

Gun locked

(gun will not spray)

GUN MODELS GX-08AND

GX-10

To lock the gun, turn the trigger lock forward and slightly down until it stops.

The spray tip SHOULD NOT be attached until after the sprayer and paint hose have been purged and primed.

© 2003 Wagner Spray Tech - All rights reserved.

5

Customer Service: 800-880-0993

English

Page 5
Image 5
Wagner SprayTech 9210 Setup--Assembling The Sprayer, GX-06/07, GX-08/10, GX-07, GX-10, Tools Needed For Setup, English