Wasp Bar Code W-300 manual Power Supply, Parallel Interface Requirements

Quick Setup Guide

Connecting the Printer

Power Supply

Note: The power supply must be connected into the back of the printer before connecting the communication cables.

1.The Power Adapter has a barrel connector on one end that must be inserted into the power jack on the back of the printer.

2.Plug the other end of the cord into an appropriate 120V AC electrical outlet.

Parallel Interface Requirements

Note: This printer complies with FCC “Rules and Regulations”, Part 15, for Class B Equipment, using fully shielded six-foot data cables. Use of longer cables or unshielded cables may increase radiated emissions above the Class B limits.

The included cable (IEE 1284-compliant) has a standard 36-pin parallel connector on one end, which is plugged into the parallel port located on the back of the printer. The other end of the parallel interface cable connects to the parallel port on the host computer.

Data cables must be of fully shielded construction and fitted with metal or metalized connector shells. Shielded cables and connectors are required to prevent radiation and reception of electrical noise.

To minimize electric noise pickup in the cable:

1.Keep data cables as short as possible (6 feet recommended).

2.Do not tightly bundle the data cables with power cords.

3.Do not tie the data cables to power wire conduits.

3