Allied Telesis Guide to Using AlliedWare Plus Operating System Commands for Switch Configuration

Entering the

AlliedWare Plus

Operating System

Commands

SwitchBlade x8106 Chassis Switch Installation Guide

2.Connect the other end of the cable to an RS-232 port on a terminal or personal computer with a terminal emulation program.

3.Configure the VT-100 terminal or terminal emulation program as follows:

Baud rate: 115,200 bps

Data bits: 8

Parity: None

Stop bits: 1

Flow controller: None

Note

The port settings are for a DEC VT100 or ANSI terminal, or an equivalent terminal emulator program.

4.Press Enter. You are prompted for a user name and password.

5.Enter the default user name and password. They are “manager” and “friend” (without the quotes), respectively

Note

User names and passwords are case sensitive.

The local management session starts and the command line interface (CLI) prompt is displayed.

To confirm the operations of the chassis with the commands in the AlliedWare Plus Operating System, perform the following procedure:

1.Enter the SHOW VERSION command in the User Exec or Privileged Exec mode to display the software version number of the AlliedWare Plus Operating System on the controller card, as shown in Figure 135 on page 186.

185