Chapter 7: Powering On the Chassis

4.Using a #1 Phillips-head screwdriver, remove the two screws that secure the plastic cover over the positive and negative terminals and remove the plastic cover from the power supply, as shown in Figure 124. You may need to lift the locking handle slightly to access the bottom screw.

Figure 124. Removing the Plastic Cover

Note

The plastic cover is not used with the right angle terminals.

5.Use a #3 Phillips-head screwdriver to remove the two screws from the positive and negative terminals, as shown in Figure 125 on page 169.

168

Page 168
Image 168
Allied Telesis X8106 manual 168