Allied Telesis X8106 manual Replacing the AT-SBxFAN06 Fan Module, Removing AT-SBxFAN06 Fan Module

Chapter 10: Replacing Modules

Replacing the AT-SBxFAN06 Fan Module

Removing the

AT-SBxFAN06

Fan Module

This section contains the procedures for replacing the AT-SBxFAN06 Fan Module. The module is located in the slot on the right side of the front panel.

Caution

Although the fan module is hot swappable and can be replaced while the chassis is powered on, the line cards and power supplies may overheat if the chassis is operated for more than one or two minutes without a fan module.

Warning

The fan module has hazardous moving parts. Keep fingers away from moving fan blades.

Note

Only an authorized service technician should replace the fan module.

To remove the fan module from the chassis, perform the following procedure:

1.If necessary, disconnect or reroute network cables that are blocking access to the fan module.

2.Use a #2 Phillips head screwdriver to loosen the screw at the base of the fan module. Refer to Figure 153 on page 227.

226