SwitchBlade x8106 Chassis Switch Installation Guide

7.Connect the fiber optic cable to the port on the transceiver, as shown in Figure 87. The connector should snap into the port.

Figure 87. Attaching a Fiber Optic Cable to an SFP Transceiver in the AT-

SBx81GS24a Line Card

8. Repeat this procedure to install additional SFP transceivers.

After installing and cabling the SFP transceivers, do one of the following:

To install and cable additional transceivers, go to the appropriate section in this chapter for instructions.

After cabling all the ports in the chassis, go to Chapter 7, “Powering On the Chassis” on page 143.

133

Page 133
Image 133
Allied Telesis X8106 manual 133