SwitchBlade x8106 Chassis Switch Installation Guide

AT-SBxPWRPOE1 Power Supply

The AT-SBxPWRPOE1 Power Supply, shown in Figure 24, provides the PoE power for the ports on the AT-SBx81GP24 PoE Line Cards. You may install either one or two PoE power supplies in the chassis.

The AT-SBxPWRPOE1 Power Supply provides 1200 watts of power for PoE. You may install two power supplies in the chassis for a total of 2,400 watts of power.

The total number of powered devices the chassis can support depends on the number of AT-SBxPWRPOE1 Power Supplies in the chassis and the power requirements of the devices. For instance, a chassis can support 40 ports of Class 4, PoE+ (IEEE 802.3at) powered devices with one power supply or 80 ports with two power supplies. For further information, refer to Table 4 on page 36.

Figure 24. AT-SBxPWRPOE1 Power Supply

Power supply modules are not included with the chassis and must be purchased separately.

The AT-SBxPWRPOE1 Power Supplies are installed in the two left hand slots, labeled A and B, at the top of the front of the chassis. If you are installing only one power supply, you may install it in either slot. The locations of the slots are shown in Figure 6 on page 23.

The AT-SBxPWRPOE1 Power Supply is hot swappable. You do not have to power off the chassis to install or remove the power supply.

LEDs The LEDs on the AT-SBxPWRPOE1 Power Supply are described in Table 15 on page 56.

55

Page 55
Image 55
Allied Telesis X8106 manual AT-SBxPWRPOE1 Power Supply