Connecting Cables to the AT- SBx81GT40 Line Card
SwitchBlade x8106 Chassis Switch Installation Guide
The default wiring configuration of the ports is automatic MDIX detection, which configures the MDI/MDIX setting automatically. This setting is appropriate for switch ports that are connected to network devices that also support the feature.
The default wiring configuration of automatic MDIX detection is not appropriate for ports that are connected to network devices that do not support the feature. On those ports, you should disable automatic MDIX detection and set the wiring configuration manually with the POLARITY command.
Here are a few additional guidelines to connecting cables to ports on the
The ports require the RJ point 5 cable connector shown in Figure 80.
Figure 80. RJ Point 5 Cable Connector for AT-SBx81GT40 Line Card
To connect a cable to a port in the top role on the line card, orient the connector with the release tab on top. To connect a cable to a port in the bottom role, orient the connector with the release tab on the bottom. Refer to Figure 81 on page 128.
To remove a cable from a port, pull gently on the release tab and slide the cable connector from the port.
Note
Patch cables for the AT-SBx81GT40 Line Card, in lengths of 1 meter and 3 meters with RJ point 5 and RJ-45 connectors, are available from Allied Telesis. Contact your Allied Telesis sales representative for information.
127
