NET MGMT LED

SwitchBlade x8106 Chassis Switch Installation Guide

The NET MGMT port has a standard RJ-45 8-pin connector and operates at 10, 100, or 1000 Mbps in either half- or full-duplex mode. The cable requirements for this port are the same as the ports on the AT- SBx81GT24 Line Card, listed in Table 1 on page 33. For the port pinouts, refer to “Port Pinouts” on page 239.

The default setting for the port is Auto-Negotiation, which sets the speed and duplex mode automatically. You may disable Auto-Negotiation and configure the port manually. The port is referred to as ETH0 in the AlliedWare Plus Operating System.

The wiring configuration of the NET MGMT port is set automatically with automatic MDIX detection. You may disable automatic MDIX detection and set the wiring configuration manually.

The Network Management (NET MGMT) port on the AT-SBx81CFC400 Controller Fabric Card has one Status LED, described in Table 13.

Table 13. NET MGMT Port LED

LED

State

Description

 

 

 

 

 

 

 

Solid Green

The port has a valid 1000 Mbps link.

 

 

 

 

Flashing

The port is transmitting or receiving data at

 

Green

1000 Mbps.

L/A

 

 

Solid Amber

The port has a valid 10 or 100 Mbps link.

 

 

 

 

 

Flashing

The port is transmitting or receiving data at

 

Amber

10 or 100 Mbps.

 

 

 

 

Off

The port has not established a link to a

 

 

network device.

 

 

 

Console (RS-232) Port

The Console Port is used to conduct local management sessions with the switch. Local management sessions are established with a terminal or PC with a terminal emulation program, and the management cable that comes with the card.

Local management is referred to as out-of-band management because it is not conducted over a network. Consequently, the AT-SBx81CFC400 Controller Fabric Card does not need an Internet Protocol (IP) address for this type of management.

Your initial management session with the switch must be a local management session. For instructions on how to start a local management session, refer to “Using Local Management to Verify the Chassis” on page 184 or the Software Reference for SwitchBlade x8100 Series Switches.

51

Page 51
Image 51
Allied Telesis X8106 manual NET Mgmt LED