Connecting the
DC Power Wires
with the Right
Angle Terminals
SwitchBlade x8106 Chassis Switch Installation Guide
To connect the DC power wires to the positive and negative terminals on the power supply with the right angle terminals, perform the following procedure:
1.Prepare adequate lengths of two stranded 8 AWG power wires by stripping them as shown in Figure 122.
Warning
Do not strip more than the recommended amount of wire. Stripping more than the recommended amount can create a safety hazard by leaving exposed wire on the terminal block after installation. E10
Figure 122. Stripping the Power Wires
Note
You must use stranded wires with the terminal lugs. You may not use solid wires.
2.Verify that the On/Off switch on the AT-SBxPWRSYS1 DC Power Supply is in the Off position. Refer to Figure 115 on page 160.
3.Insert the power wires into the right angle terminals included with the power supply and use a crimping tool to secure the wires to the terminals. See Figure 123,
Figure 123. Attaching the Power Wires to the Right Angle Terminals
167
