Allied Telesis X8106 manual Installing the AT-SBx81CFC400 Controller Fabric Card

Chapter 5: Installing the AT-SBx81CFC400 Controller and Ethernet Line Cards

Installing the AT-SBx81CFC400 Controller Fabric Card

This section contains the installation procedure for the AT-SBx81CFC400 Controller Fabric Card. You may install either one or two controller cards in the unit. The chassis must have at least one controller card. The cards must be installed in slots 5 and 6 in the chassis.

Note

Please review “Guidelines to Handling the Controller and Line

Cards” on page 110 before performing this procedure:

This procedure requires the following tools:

#2 Phillips-head screwdriver (not provided)

#2 Phillips-head, 5 inch-lbs torque screwdriver (optional — not provided))

To install the AT-SBx81CFC400 Card, perform the following procedure:

1.Choose a slot in the chassis for the AT-SBx81CFC400 Controller Fabric Card.

The card must be installed in slot 5 or 6, shown in Figure 66. If you are installing only one controller card, Allied Telesis recommends installing it in slot 5.

Slot 5 Slot 6

Figure 66. Slots 5 and 6 for the AT-SBx81CFC400 Card

2.Remove the new AT-SBx81CFC400 Control Card from the shipping package and verify the package contents, listed in Table 67 on page 113.

If any item is missing or damaged, contact your Allied Telesis sales representative for assistance.

112