SwitchBlade x8106 Chassis Switch Installation Guide

Replacing the AT-SBxPWRSYS1 DC Power Supply

To remove an AT-SBxPWRSYS1 DC Power Supply from the chassis, perform the following procedure:

1.Turn off the circuit breaker to the AT-SBxPWRSYS1 DC Power Supply.

2.Turn off the On/Off switch on the front panel of the power supply. Refer to Figure 103 on page 152.

3.Use a #2 screwdriver to loosen the screw on the locking handle. Refer to Figure 142.

Note

Do not lift the locking handle yet.

Figure 142. Loosening the Screw on the Locking Handle

211

Page 211
Image 211
Allied Telesis X8106 manual Replacing the AT-SBxPWRSYS1 DC Power Supply, Loosening the Screw on the Locking Handle