Chapter 4: Installing the Power Supplies

7.Lower the locking handle of the power supply module to secure the module in the slot, as shown in Figure 64.

Figure 64. Locking the Handle on the AT-SBxPWRSYS1 Power Supply

Note

Do not tighten the handle locking screw yet. You may need to slightly lift the handle to move the plastic guard panel when you wire the positive and negative wires in “Powering On the AT- SBxPWRSYS1 DC System Power Supply” on page 151.

8.To install a second AT-SBxPWRSYS1 DC Power Supply, repeat this procedure.

9.After installing the AT-SBxPWRSYS1 DC Power Supplies, go to Chapter 5, “Installing the AT-SBx81CFC400 Controller and Ethernet Line Cards” on page 109.

Note

Retain the five wire ring lugs that come with the power supply. You use them to wire the power supply in “Powering On the AT- SBxPWRSYS1 DC System Power Supply” on page 151

108

Page 108
Image 108
Allied Telesis X8106 manual 108