Allied Telesis X8106 manual SBx Status LEDs

SBx STATUS LEDs

SwitchBlade x8106 Chassis Switch Installation Guide

The SBx LINECARD STATUS LEDs display general status information about the Ethernet line cards and controller cards. There are twelve LEDs, numbered 1 to 12. Only LEDs 1 to 6 are used. They correspond to slots 1 to 6 in the AT-SBx8106 Chassis. LEDs 7 to 12 are not used. If the chassis has two controller cards, the SBx Status LEDs are active on both cards. The LEDs are defined in Table 11.

Table 11. SBx LINECARD STATUS LEDs

LEDs	State	Description
	Solid Green	Indicates that the Ethernet line or controller
1 to 12		card is operating normally.
	Flashing Green	Indicates that the card is booting up,
		running in test mode, or loading its
		configuration settings.
	Solid Amber	Indicates that the card is in an off-line state.
		Possible causes are:
		 An Ethernet line card that displays this
		LED state may have encountered a
		problem initializing the management
		software.
		 An Ethernet line card that displays this
		LED state might not be able to boot up
		because the controller card does not
		have the appropriate load file and
		needs to be updated to the most recent
		release of the management software.
		 A standby master controller card that
		displays this LED state may have been
		disabled by the active master controller
		card because the cards have
		incompatible versions of the
		management software and were unable
		to resolve the problem, possibly
		because of insufficient free flash
		memory.
		You may remove a line or controller card
		from the chassis when it is in this state.
	Flashing Amber	Indicates that the card is reporting a fault
		condition. Use the management commands
		to determine the specific problem.

47