SwitchBlade x8106 Chassis Switch Installation Guide

Installing the AT-SBxPWRPOE1 PoE Power Supply

This section contains the installation procedure for the AT-SBxPWRPOE1 Power Supply, for the PoE+ ports on the AT-SBx81GP24 PoE Line Card. For background information, refer to “AT-SBxPWRPOE1 Power Supply” on page 55.

Caution

The electronic components in the AT-SBxPWRPOE1 PoE Power Supply can be damaged by electro-static discharges (ESD). Follow the procedure in “Protecting Against Electrostatic Discharge (ESD)” on page 90 to guard against ESD damage when unpacking and installing the power supply.

To install the power supply, perform the following procedure:

1.Choose a slot for the AT-AT-SBxPWRPOE1 System Power Supply in the chassis.

You may install it in either slot A or B, shown in Figure 46 on page 91.

2.Raise the handle on the blank panel covering the selected slot and slide the panel from the chassis. Figure 53 on page 98 shows the blank panel being removed from slot A.

97

Page 97
Image 97
Allied Telesis X8106 manual Installing the AT-SBxPWRPOE1 PoE Power Supply