WDT 3200 Product Reference Guide
Before You Begin Using Your WDT3200
Before using the WDT3200, please ensure the battery is fully charged. There are three ways to charge your WDT3200:
Docking Station
RS232/Charging cable or USB/Charging cable
Rechargeable
CAUTION: There is a high risk of data loss if the WDT3200's backup battery is not fully charged. This data loss can occur if the main battery has been drained and the unit is not connected to the AC adaptor. For this reason, it is crucial that before you charge the main battery, you make sure the backup battery switch is set to ON. For further information on turning on the backup battery switch, please see the next page.
Wasp Barcode Technologies recommends that you charge the battery at least 12 hours before using for the first time. After the initial charge, a fully drained battery can be recharged in about 4 hours. While charging the main battery the backup battery will also be charged if the backup battery switch is set to “ON”.
Installing the Battery Pack
1.Remove the battery door.
2.Move the backup battery switch to the ON position.
On
Off
10
