Page 18 | WATERPIK TECHNOLOGIES INC. |
|
|
|
|
3B-2. Model LG (Standing Pilot)
FOR YOUR SAFETY READ BEFORE OPERATING 
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
A.This appliance has a pilot which must be lighted by a push button sparker. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it. Call a qualified service techni- cian. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a quali- fied service technician to inspect the appli- ance and to replace any part of the control system and any gas control which has been under water.
OPERATING INSTRUCTIONS 
1.STOP! Read the safety information above.
2.Set the thermostat to lowest setting and turn appliance ON/OFF switch to "OFF".
3.Turn gas control knob clockwise 
until it stops at "OFF" position.
4.Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow "B" in the safety information above. If you don't smell
gas go to the next step.
5. To find
6.Turn knob on gas valve
counterclockwise
to
"PILOT" then push control 
knob all the way and hold down.TO VALVE
7.Push the button of the sparker, repeating until confirming that pilot lights, by observing reflection on burner tray mirror.
8.Continue to hold the control knob down for about one (1) minute after the pilot is lit. If it goes out, repeat steps 3 through 8.
• If knob does not pop out when released, stop and immediately call your service technician or gas supplier.
•If the pilot will not stay lit after several tries, turn the gas control knob to "OFF" and call your service technician or gas supplier.
9.Turn gas control knob counterclockwise
to "ON".
10.After replacing control compartment access panel, set thermostat to desired setting and turn appliance ON/OFF switch to "ON". Valve has
11.If the appliance will not operate, check that the filter pump is on, that the filter is clean and water is flowing to the pool. Otherwise, follow the instructions "To Turn Off Gas To Appliance" and call your service technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE
1.Set the thermostat to lowest setting and turn appliance ON/OFF switch to "OFF".
2.Turn gas control knob clockwise 
until it stops at "PILOT". Then press down slightly
on knob while turning clockwise 
to "OFF". Do not force.
