HINGES
NOTE: Top sections do not require hinges.
Use the ENDHINGE CHART to determine the proper endhinges for the proper section. Install only the left hand end hinge, as the right hand end hinge will need to be installed when the sections are stacked. Align the proper left hand end hinges to the proper sections using the center line of the endstile as a guide and the 2 punch marks in the endstile to locate the placement of the end hinge. Secure using (2) 1/4” x 7/8” self drilling screws as shown in FIG E. Sections with double end stiles require 2 end hinges per side on each section, as shown in FIG F.
The end hinge sequence is dependent on track size (2” or 3”).
2” track applications begin with #1 hinges attached to the top corners of the bottom section. 3” track applications begin with #3 hinges attached to the top corners of the bottom section.
To install center hinges on doors without integral ribs, place the center hinge over the center stile(s), using the center line of the stile(s) as a guide, and secure to the section using (2) 1/4” x 7/8” self drilling screws, as shown in FIG G.
To install center hinges on doors with integral ribs, seat the bottom half of the half hinge(s) onto the integral rib above the center stile(s) and over the punch marks of each section, and secure to the rib with (2)
END STILE |
|
END STILE PUNCH MARKS |
|
CENTER LINE | ATTACHED HINGE |
1/4” 7/8” SELF- |
|
DRILLING SCREWS |
|
| FIG E |
DOUBLE |
END STILE |
ATTACHED HINGE |
1/4” X 7/8” SELF- |
DRILLING SCREWS |
FIG F |
SECTIONS WITHOUT
INTEGRAL RIBS
1/4” X 7/8” SELF-
DRILLING SCREWS
| CENTER LINE |
|
ENDHINGE CHART |
| |
Section | 2 inch track | 3 inch track |
Bottom | #1 hinge | #3 hinge |
Second | #2 hinge | #4 hinge |
Third | #3 hinge | #5 hinge |
Fourth | #4 hinge | #6 hinge |
Fifth | #5 hinge | #7 hinge |
Sixth | #6 hinge | #8 hinge |
Seventh | #7 hinge | #9 hinge |
SECTIONS WITH
INTEGRAL RIBS
INTEGRAL RIB | HALF HINGE |
| |
CENTER | PUNCH MARKS |
| |
STILE |
|
(2)1/4”- 20 X 5/8” |
|
CARRIAGE BOLTS |
|
| HINGE |
| (2) 1/4” X 20 |
| FLANGE HEX |
| NUTS |
CENTER STILE |
|
FIG G
Hinges are stamped with their identification. | 5 |
