HOOK LEFT HAND
ROLLER INTO TRACK
LOCK SECTION
SLIDE RIGHT ENDHINGE AND ROLLER DOWN VERTICAL TRACK AND OVER LOCK SECTION
FIG I
TOP BRACKETS/ TOP SECTION
Align upper-center hole of top bracket with vertical groove on the end stile and ensure top bracket is level and aligned with edge of top section. Secure with (4) 1/4”- 20 x 7/8” self drilling screws, one in each corner of the top bracket, as shown in FIG J. Loosely fasten top bracket slide with (1) 5/16” x 3/4” carriage bolt and flange hex nut. Insert roller into slide. Repeat for other side. If your door has double end stiles then it will require 2 top brackets; as shown in FIG K, in which case an additional top bracket will be installed in the same manner next to the first top bracket with one roller being placed through both top bracket slides. 2 reinforcement brackets will then be installed under the 2 top brackets and secured to the section with (2) 1/4”- 20 X 7/8” self drilling screws.
If your door is trolley operated; it is recommended that an optional strut be installed on the top rail.
Now stack the top section, take care to ensure it is aligned properly with the other sections.
TOP BRACKET | | | | |
BASE | TOP SECTION | | (1) 5/16” X 3/4” |
| |
| | | CARRIAGE BOLT |
| | | TOP | TOP SECTION |
| | | |
| | | BRACKET | |
| (4) 1/4”- 20 X 7/8” SELF | | SLIDE | |
| | TOP | |
END STILE | DRILLING SCREWS | FLANGE HEX NUT | |
BRACKET | |
| |
| | | BASE | |
| | FIG J | | |
| TOP SECTION | | (2) 1/4”- 20 X 7/8” SELF |
| | |
| | | DRILLING SCREWS | |
| (8) 1/4”- 20 X 7/8” SELF | | | |
| DRILLING SCREWS | (2) REINFORCEMENT | | |
| | | |
| | BRACKETS | | |
| | FIG K | | |
| | | | 7 |
